In principle, it is contemplated, all type of plastic injection mold, standardized or customized, large or small, cold nozzle or hot chamber, with the various mechanisms of skids and runners possible.

   In principle, it is contemplated, all type of plastic injection mold, standardized or customized, large or small, cold nozzle or hot chamber, with the various mechanisms of skids and runners possible.

  After selecting the type of frame, suitable for the previously prepared piece, proceed to place and define injection, ejectors, water circuits, hydraulic cylinders, etc. Through a program, the hardware store is selected according to pre-established criteria.

  On the other hand, the cooling circuits consist of uniform meshes, located in planes of the two figure support plates, with wells directed to the figure.

     Slides and runners, are defined by the coordinates of the point of incidence in the figure, the angle of orientation, the angle of inclination, height and width of the affected figure, and some more parameters.

   The rigorous correspondence between labels, views and list of materials allows to understand the plans without being an expert in the sector.